Sorry for the book in advance, just want to make sure I outline all the steps I did to try to get to the bottom of this. I picked up an Element14 Industrial Version of the BBB. Trying to get Python 3.6 installed to find out that it's not supported on the Debian 8.11 that was running. Went to Beaglebone images and downloaded "AM3358 Debian 10.3 2020-04-06 4GB eMMC IoT Flasher" and used Win32DiskImager to flash it to a microSD card. I also uncommented the "#cmdline=init=/opt/scripts/tools/eMMC/init-eMMC-flasher-v3.sh" at the bottom of the uEnv.txt file. Flash seemed to go fine, the LEDs went back and forth then on one attempt, the LEDs were all flashing on and off at the same time. I unplugged here thinking it was done, but apparently it wasn't. Went back and managed to flash again (saw lights going up and down in order/etc) then waited for it to totally turn off. After all LEDs were off I unplugged the BBB and now the heartbeat flashes a few times then all goes dark. No lights or anything. The only weird part is if I put the flasher microsd card in that I made (can confirm I used the flasher image) then it will boot and it's still running Debian 8.11. Anyone have any ideas as to what in the world might be going on? Thanks in advance!
-- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to beagleboard+unsubscr...@googlegroups.com. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/86cfa146-62ef-41d5-9247-0870d25a14a1%40googlegroups.com.