If you really want a GUI debugger you might consider Padre. I've used it as a debugger once or twice, but recall running into issues. Note that Padre has been a stale project for a while, so it may not even install.
A safe bet, if non-gui, is the perl debugger, as already mentioned. David On Mon, Jul 17, 2017 at 4:39 PM, Andrew Solomon <and...@geekuni.com> wrote: > There's also a very nice tutorial here http://techblog.net-a- > porter.com/2014/03/learning-the-perl-debugger-introduction/ > > On Mon, Jul 17, 2017 at 8:54 PM, Chas. Owens <chas.ow...@gmail.com> wrote: > >> Perl has a built in debugger. You can say >> >> perl -d abc.pl >> >> And it will stop at the first executable line (ignoring BEGIN blocks and >> use statements). You can then step through or over the code. See >> https://perldoc.perl.org/perldebug.html or perldoc perldebug for more >> information. >> >> On Mon, Jul 17, 2017 at 3:48 PM Asad <asad.hasan2...@gmail.com> wrote: >> >>> Hi All , >>> >>> I am new to perl , I a have a abc.pl script and abc.pm module >>> . I want to understand when I execute abc.pl hw to get to a debug state >>> to identify what values does it take . Any GUI interface available to see >>> the flow of events. >>> >>> >>> -- >>> Asad Hasan >>> +91 9582111698 <+91%2095821%2011698> >>> >> > > > -- > Andrew Solomon > > Mentor@Geekuni http://geekuni.com/ > http://www.linkedin.com/in/asolomon > -- "Debugging is twice as hard as writing the code in the first place. Therefore, if you write the code as cleverly as possible, you are, by definition, not smart enough to debug it." -- Brian Kernighan
