On Tue, Jan 21, 2003 at 07:48:27PM -0500, Pete Emerson <[EMAIL PROTECTED]> wrote:
> You were going for the contents of $file1, correct?
Correct.
>
> Here's my stab. Read in the target files first, then match.
> When it walks through the source file, it will print out the name of all
> target files that match.
>
I tried your program, it ran for a couple of minutes then exited cleanly but without
giving me any info. The program just returned to the shell prompt.
Maybe I wasn't clear enough in my original post.
The input file contains only a domainname on each line.
What I didn't specify however was that the 3 target files are BIND8 named.conf style
files.
The input file only contains lines like:
foo.com
But the target file(s) look like this: (example specified is just an example)
zone "foo.com" {
type master;
file "pri/foo.com";
};
So, the string is in 1 of the 3 target files, but, unfortunately, your program didn't
match the string from the input file.
Fenx again.
Gr,
--
Marco van Lienen <[EMAIL PROTECTED]>
GPG:0x8580E6CB Available on keyservers.
We are BitchX of Borg. You will be assimilated. Using mIRC is futile
S@H:6558WU/11.067yr --> setiathome.ssl.berkeley.edu Put those CPU cycles to use!
Why did it happen ? BOFH Excuse:
new management
--
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
