Hello,
Wake On Lan doesn't work for the following on board NIC card in a HP VL400
computer :
01:04.0 Ethernet controller: 3Com Corporation 3c905C-TX/TX-M [Tornado] (rev
7
I'm using Ubuntu(Edgy)
I've tried already with the following :
1)
Add the following to /etc/modules
3c59x options=0x408
2)
Add the following to /etc/modules
options 3c59x enable_wol=1
but without success.
I've the same machine but with windows xp installed on it, and there it
works.
Wake on Lan is enabled in the BIOS
Some outputs
[EMAIL PROTECTED]:~$ sudo ethtool eth0
Password:
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: MII
PHYAD: 24
Transceiver: internal
Auto-negotiation: on
Current message level: 0x00000001 (1)
Link detected: yes
[EMAIL PROTECTED]:~$
I don't have the following lines
Supports Wake-on: g
Wake-on: g
and this is not a good sign.
Maybe the driver is not good in Ubuntu?
Does somebody have some other ideas?
With kind regards
Alef
_______________________________________________
Beowulf mailing list, [email protected]
To change your subscription (digest mode or unsubscribe) visit
http://www.beowulf.org/mailman/listinfo/beowulf
