On 05/15/10 08:44, Andrew Piskorski wrote:
SGE does this and can make it available as XML.
Which reminds me, I need to look harder to figure out WHERE exactly
SGE stores its node configuration data, and how I can perhaps extend
it with additional information, like the network topology between my
nodes. This is probably simple but it wasn't obvious from the
(voluminous) SGE docs.
I think it depends on whether you're using text or BDB as your backend.
If you're using text, it'll be in $SGE_ROOT/$SGE_CELL, with
node-specific customizations in $SGE_ROOT/$SGE_CELL/local_conf. I'm not
sure about BDB though.
--
-- Skylar Thompson ([email protected])
-- http://www.cs.earlham.edu/~skylar/
_______________________________________________
Beowulf mailing list, [email protected] sponsored by Penguin Computing
To change your subscription (digest mode or unsubscribe) visit
http://www.beowulf.org/mailman/listinfo/beowulf
