>> out of curiosity, has anyone set up a head-to-head comparison
>> (two or more identical machines, both with a Qlogic and a Mellanox card of
>> the same vintage)?
>>
>> There was a bit of discussion of InfiniBand benchmarking in this thread
> and it seems it would be helpful to the casual readers like myself to have
> a few references to benchmarking toolkits and actual results.
>
> Most often reported results are gathered with either Netpipe from Ames or
> Intel MPI Benchmark (formerly known as Palas Benchmark) or OSU
> Micro-benchmarks.
>
> Searching the web produced a recent report from Swiss CSCS where a Mellanox
> ConnectX3 QDR HCA with a Mellanox switch is set against a Qlogic 7300 QDR
> HCA connected to a Qlogic switch.
> http://www.cscs.ch/fileadmin/user_upload/customers/cscs/Tech_Reports/Performance_Analysis_IB-QDR_final-2.pdf
as far as I can tell, this paper mainly says "a coalescing stack delivers
benchmark results showing a lot higher bandwidth and message rate than a
non-coalescing stack." the comment on figure 8:
To some extent, the environment variables mentioned before
contribute to this outstanding result
which is remarkably droll. I'm not sure how well coalescing works for real
applications.
_______________________________________________
Beowulf mailing list, [email protected] sponsored by Penguin Computing
To change your subscription (digest mode or unsubscribe) visit
http://www.beowulf.org/mailman/listinfo/beowulf
