Bill,
I've just tried keyboard input in j801 and j64-801 on my
windows machine. "input" does in fact work under j64-801.
But not the 32-bit j801. To make sure, I did a fresh install
of j801. Same result as I reported below. Annoying, as I
can't use LAPACK under j64-801.
There is something funny about my Windows 7 j801 installations,
however. If I try to start j64-801 with the J icon in the folder
j64-801/bin/ it fails with "The program can't start because
QtCore4.dll is missing from your computer". I start J by clicking
on j64-801/jqt.cmd, which is not in the bin folder. That file
sets paths and then calls bin\jqt.exe. Same with the 32-bit j801.
Patrick
On Fri, 31 May 2013, bill lam wrote:
Patrick,
I thought the keyboard input should have already been fixed awhile
ago. Can you confirm it still crashs?
Чт, 30 май 2013, J. Patrick Harrington писал(а):
Bill,
I've found that problem - indeed IFQT gave 0 on my installation.
So I reinstalled (just as I'd done before) and IFQT gave 1. And
viewmat and plot worked! Then I loaded my profile of definitions
and things stopped working and IFQT was zero again. Upon looking
into my profile, I found at the end
IFQT_z_=: 0
Duh! I put that in the last time we were trying to run down some
problem & I forgot to remove it. I see that the
"Graphics - gl2 commands" also seems to run.
Many thanks for your patience in helping with this silly error.
My problem which stops me from using j801 on my windows machine is
something I brought up earlier: I make a lot of use of keyboard
input in programs:
enter=: [:". 1!:1&1:
a=. enter''
If I use that, J crashes - pops a box that says "jqt.exe has
stopped working" Any ideas what might cause that? "enter" works
in j601, j602 & j701 on this machine (Windows 7).
Patrick
----------------------------------------------------------------------
For information about J forums see http://www.jsoftware.com/forums.htm
