Hello, Julian,
I suspect it skipped building bgljfile since you originally build without jvm
support. Can you cd into the bde directory and run make? This should build
bgljfile. Once done, you should be able to run make again from the top-level
and have the compilation succeed.
Best Regards,Joe
On Thursday, April 30, 2020, 2:01:32 PM PDT, Julián Herrera
<[email protected]> wrote:
I ran
./configure --jvm=yes
configure runs fine and spits out a summary that looks accurate.
I run make, that runs for a couple seconds but then stops at the following:
/home/jules/Code/bigloo4.3g/bin/bgljfile.sh: 19: exec:
/home/jules/Code/bigloo4.3g/bin/bgljfile: not found
Makefile:570: recipe for target '.jfile' failed
make[2]: *** [.jfile] Error 127
make[2]: Leaving directory '/home/jules/Code/bigloo4.3g/comptime'
Makefile:403: recipe for target 'bigloo' failed
make[1]: *** [bigloo] Error 2
make[1]: Leaving directory '/home/jules/Code/bigloo4.3g/comptime'
Makefile:168: recipe for target 'boot-c' failed
make: *** [boot-c] Error 2
bgljfile.sh ends with a call to exec a file which does not exist
Previously I had built bigloo successfully just running (configure, make, make
install), didn't realize the JVM integration required a seperate flag. So this
is my 2nd attempt (after running make clean) and I can't passed this step.
