Am 16.06.21 um 20:31 schrieb ToddAndMargo via bind-users:
On 6/16/21 2:16 AM, Reindl Harald wrote:
Am 16.06.21 um 09:31 schrieb ToddAndMargo via bind-users:
...
# means root
$ means user
...
Sometimes, in your configuration file extracts, you use '#' meaning
'this line is a comment'. I guess this is a write-up for a novice.
The non-novices here have overlooked it, but I'm much closer to the
novice end of the BIND user spectrum than they are and If I were a
*complete* novice, I'd find these uses of '#' very confusing.
Which lines?
lines starting with #
----------------------
here it is a comment sign
Change /etc/resolv.conf back to
search your_domain
nameserver your_IP
# nameserver 208.67.222.123
----------------------
here it is meant as command running as root
Then restart the service:
# systemctl restart bind-named.service
Does this alteration at the top make it any clearer?
Note: at the command prompt, I use the following terminology:
# means run as root
$ means run as user
Inside a file, "#" mean it is a comment
not really - either use the ubuntu "sudo everything" or just type "root:
command" and "user: command"
_______________________________________________
Please visit https://lists.isc.org/mailman/listinfo/bind-users to unsubscribe
from this list
ISC funds the development of this software with paid support subscriptions.
Contact us at https://www.isc.org/contact/ for more information.
bind-users mailing list
bind-users@lists.isc.org
https://lists.isc.org/mailman/listinfo/bind-users
