I'm trying to get an IPv6 adjacency up and running and I'm having issues. I'm hoping someone can point me in the right direction here. When I bring up bird6 I get this:
Jul 11 18:08:38 router-priamry bird6: main: Cannot find forwarding address for NSSA-LSA ::/96 Jul 11 18:08:38 router-priamry bird6: main: Cannot find forwarding address for NSSA-LSA ::/0 Jul 11 18:08:38 router-priamry bird6: main: Cannot find forwarding address for NSSA-LSA ::ffff:0.0.0.0/96 Followed by this, repeatedly, forever: Jul 11 18:21:15 router-priamry bird6: OSPF: Received non-hello packet from unknown neighbor (src fe80::c67d:4fff:fe9f:945, iface em0) The relevant interface config: em0: flags=8943<UP,BROADCAST,RUNNING,PROMISC,SIMPLEX,MULTICAST> metric 0 mtu 1500 options=9b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM> ether 00:0c:29:9c:5c:28 inet 70.32.199.66 netmask 0xffffffe0 broadcast 70.32.199.95 inet6 fe80::20c:29ff:fe9c:5c28%em0 prefixlen 64 scopeid 0x1 inet 70.32.199.65 netmask 0xffffffff broadcast 70.32.199.65 vhid 1 nd6 options=23<PERFORMNUD,ACCEPT_RTADV,AUTO_LINKLOCAL> media: Ethernet autoselect (1000baseT <full-duplex>) status: active carp: MASTER vhid 1 advbase 1 advskew 0 The bird config: log syslog all; debug protocols all; router id 70.32.199.66; protocol kernel { learn; # Learn all alien routes from the kernel # persist; # Don't remove routes on bird shutdown scan time 20; # Scan kernel routing table every 20 seconds import all; # Default is import all export all; # Default is export none # kernel table 5; # Kernel table to synchronize with (default: main) } # This pseudo-protocol watches all interface up/down events. protocol device { scan time 10; # Scan interfaces every 10 seconds } protocol ospf main { # tick 2; # rfc1583compat yes; import all; export all; area 900 { stub; nssa; interface "em0" { hello 1; dead 4; type broadcast; }; }; } And the config from the Cisco side: interface Vlan881 ip address 70.32.199.94 255.255.255.224 ip policy route-map LAB ipv6 enable ipv6 ospf hello-interval 1 ipv6 ospf 100 area 900 end ! route-map LAB permit 5 match ip address LAB set ip next-hop 10.120.0.93 ! ip access-list extended LAB permit ip 70.32.199.64 0.0.0.31 any ! ipv6 router ospf 100 router-id 10.120.9.1 area 900 nssa passive-interface default no passive-interface Vlan881 ... redistribute connected redistribute static ! Regards, Daniel