Was this an existing circuit from an old PBX? They might be ground start trunks.
Wire an analog phone up at the demarcation and see if you can call out on it. That's often the easiest way to test analog circuits. Also, just a bit of trivia; in the US the amphenol connector is called an RJ-21, but it Canada it is a CA-21. Having said that, feel free to use whatever term you want since RJ-21 is probably more common (though Bell will call it a CA-21) > -----Original Message----- > From: Mansel Lavery [mailto:[EMAIL PROTECTED] > Sent: June 6, 2006 6:05 PM > To: [email protected] > Subject: [biz] Bell Telephone > > Asterisk User Group, > > I've recently acquired a TDM2400 for my office and have setup > the Asterisk network internally without a problem. However, I > cannot seem to get an outside line using the TDM2400 though > the Asterisk logs and phone confirm an ongoing call. > > Our line provider is Bell who runs an RJ-21 cable into a > patch board which then runs another RJ-21 into the card. > > Has anyone had similar problems with Bell? I am currently > using Kewl signaling and wondered if they used a different > type or required a longer wait before attempting to dial. > > Thank you > > Manny > > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] For > additional commands, e-mail: [EMAIL PROTECTED] > > > > -- > No virus found in this incoming message. > Checked by AVG Free Edition. > Version: 7.1.394 / Virus Database: 268.8.2/356 - Release > Date: 05/06/2006 > > -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.1.394 / Virus Database: 268.8.2/356 - Release Date: 05/06/2006
