On Wed, Jun 18, 2014 at 06:17:34PM -0500, Bruce Dubbs wrote: > Ken Moffat wrote: > > I know you do special things. All I did was follow BLFS. Did you say that > it works fine if you transfer the DVD to hard disk?
No, I checked earlier (a .vob) and it shows a similar problem. > If so, then the problem > is almost certainly a dvd driver/hw issue. I have: > > [ 2.183354] ata1.00: configured for UDMA/100 > [ 2.188946] scsi 0:0:0:0: CD-ROM TSSTcorp CDDVDW SU-208FB TF01 PQ: 0 > ANSI: 5 > [ 2.205397] sr0: scsi3-mmc drive: 24x/24x writer dvd-ram cd/rw xa/form2 > cdda tray > [ 2.206277] cdrom: Uniform CD-ROM driver Revision: 3.20 > [ 2.207283] sr 0:0:0:0: Attached scsi CD-ROM sr0 > [ 2.207343] sr 0:0:0:0: Attached scsi generic sg0 type 5 > > # > # SCSI device support > # > CONFIG_SCSI_MOD=y > # CONFIG_RAID_ATTRS is not set > CONFIG_SCSI=y > CONFIG_SCSI_DMA=y I wondered about that one, but it seems that I have indeed been using it. > # CONFIG_SCSI_TGT is not set > # CONFIG_SCSI_NETLINK is not set > CONFIG_SCSI_PROC_FS=y > > # > # SCSI support type (disk, tape, CD-ROM) > # > CONFIG_BLK_DEV_SD=y > # CONFIG_CHR_DEV_ST is not set > # CONFIG_CHR_DEV_OSST is not set > CONFIG_BLK_DEV_SR=y > CONFIG_BLK_DEV_SR_VENDOR=y > CONFIG_CHR_DEV_SG=y > # CONFIG_CHR_DEV_SCH is not set > # CONFIG_SCSI_MULTI_LUN is not set I think I tend to set that (I have a card reader which I sometimes use) > CONFIG_SCSI_CONSTANTS=y I do have that set, no idea if it is relevant. > # CONFIG_SCSI_LOGGING is not set > # CONFIG_SCSI_SCAN_ASYNC is not set > > # > # SCSI Transports > # > CONFIG_SCSI_SPI_ATTRS=y > ... > > CONFIG_ATA=y I think the _ATA and _SATA options mean that either the kit works, or it doesn't. On xine I can make DVD replay work, and I have also done so in parole. Full disclosure - with eudev-1.6, whatever workaround I used to use to get /dev/sr0 usable by normal users, and with a /dev/dvd symlink, does not work - or perhaps I dropped the ball and the fix. At the moment I don't have a eudev-1.7 system, but anyway I can make xine work if root fixes things up for the current boot - vlc was already set for /dev/sr0 and worked (for a second at a time) as a regular user. > > -- Bruce Thanks for the suggestions. ĸen -- Nanny Ogg usually went to bed early. After all, she was an old lady. Sometimes she went to bed as early as 6 a.m. -- http://lists.linuxfromscratch.org/listinfo/blfs-support FAQ: http://www.linuxfromscratch.org/blfs/faq.html Unsubscribe: See the above information page
