31. Oct 2015 15:07 by [email protected]:
> On 10/30/2015 05:46 AM, > [email protected]> wrote: >> 29. Oct 2015 17:17 by >> [email protected]>> : >> >> >>> On 10/29/2015 11:35 AM, >>> [email protected]>>> wrote: >>> >>>> >>>> >>>> >>>> >>>> >>>> If I remember correctly, which I'm not sure, you need to >>>> install docbook-xml and perform the commands in the >>>> configuration information section. >>>> >>>> >>>> >>>> >>>> It mentions you need it when you use scrollkeeper but it's >>>> also needed for xdg-utils. I think the book needs to be >>>> updated if this is correct. >>>> >>>> >>>> >>>> >>>> >>> >>> I have docbook-xml installed. And when I installed docbook-xml, >>> I ran the config commands that it shows in the dockbook-xml >>> chapter. >>> Are you saying that docbook-xml needs to be reinstalled / >>> reconfigured after installing xdg-utils? >>> >>> Wayne Sallee >>> >>> [email protected] >>> >> >> >> >> >> No you don't need a reinstall. However, what fixed my problems was >> the final configuration section (there are multiple sections on the >> docbook-xml page) about scrollkeeper. After I ran these commands I >> could compile xdg-utils. Not sure if I got the same error as you >> did though. >> >> > > So when you installed docbook-xml you ran those commands, then later > you went back and re-ran those commands to fix the problem that you were > having? > > Wayne Sallee > > [email protected] > No, I didn't run them the first time. After much searching I found out I had to run the scrollkeeper commands.
-- http://lists.linuxfromscratch.org/listinfo/blfs-support FAQ: http://www.linuxfromscratch.org/blfs/faq.html Unsubscribe: See the above information page
