Larry, If you just want to transfer an angle without actually caring about the value of the angle measurement, then there are some devices available that may or may not help, depending on how tight of an area you are working in.
I picked up a little device from www.leevalley.com. It is just two rectangular pieces with a pivot between them. You push it into a corner or wrap it around an outside corner and then you can either take that to your chop saw and copy the angle. Or, it also has a fin at the pivot point that automatically bisects the angle for you if you need to make two cuts and fit pieces together like when you are cutting moldings. Which is exactly what I used it for and it was very useful. You could also pick up a set of angle blocks, also from lee valley, and then just fit various blocks until you find the right angle and go from there. -- Blue skies. Dan Rossi Carnegie Mellon University. E-Mail: [EMAIL PROTECTED] Tel: (412) 268-9081
