Put a wide heavy duty screwdriver or better yet some sort of flat prybar
between the top and front or side at the front corners . There should be a
little play to allow the insertation of the bar. Then pry it off. There are
spring steel sheet metal fasteners that compress when put in, but will snap
out with a little effort. Snap the front ount e edge and it should hinge on
the back, but may have to be snapped loose further back along the side.
Ron
----- Original Message -----
From: robert Gilman
To: blindhandyman@yahoogroups.com
Sent: Monday, July 12, 2010 4:28 PM
Subject: Re: [BlindHandyMan] Dryer Problem
Now just how does the top unsnap in the front.
Thanks Bob
----- Original Message -----
From: Ron Yearns
To: blindhandyman@yahoogroups.com
Sent: Monday, July 12, 2010 10:27 AM
Subject: Re: [BlindHandyMan] Dryer Problem
As Dale said, removing the back is a waste of time. I would start with the
top. It should snap free from the front and hinge towards the back. Hopefully
you can rotate the drum by hand untill you can reach the pin. If you are unable
to do this then removing the front and pulling the drum out is called for. This
will involve removing the belt and re stringing it when reinstalling. Hope you
you can get it from the top.
Ron
----- Original Message -----
From: Robert Gilman
To: blindhandyman@yahoogroups.com
Sent: Sunday, July 11, 2010 5:25 PM
Subject: [BlindHandyMan] Dryer Problem
Hi All,
I am looking for some tips on taking the dryer apart. I have a bobby pin
stuck in the drum that is grinding into the drum. Can I just unscrew all
the screws and get the back panel off and possible access the pin or will I
need to take the top off. Thanks, Bob
[Non-text portions of this message have been removed]
[Non-text portions of this message have been removed]
[Non-text portions of this message have been removed]
