> On Jul 31, 2019, at 21:32, Kenneth Porter <[email protected]> wrote:
>
> I decided to try the sqm-scripts and created an RPM to make it easy to
> install/upgrade/uninstall on my CentOS 7 system. Here's the result:
>
> <https://sewingwitch.com/ken/Stuff/sqm-scripts/>
Pretty cool! (Caveat: due to lack of a centos system I will not be able
to actually test it)
>
> An initial attempt at using simple.qos on my system killed performance and
> the interface became unusuable, but I was probably too optimistic in setting
> the bandwidth numbers based on best response from speedtest-cli. I
> temporarily disabled it until I can test during off-hours.
So maybe run the following to get some debug output:
SQM_DEBUG=1 SQM_VERBOSITY_MAX=10 /etc/init.d/sqm start ; tc -s qdisc ; tc -d
qdisc ; SQM_DEBUG=1 SQM_VERBOSITY_MAX=10 /etc/init.d/sqm stop
I would hope that this should undo its damage at the end but will also capture
the wedged state in between. Then again this still might lead to an unusable
interface....
Best Regards
Sebastian
>
> _______________________________________________
> Bloat mailing list
> [email protected]
> https://lists.bufferbloat.net/listinfo/bloat
_______________________________________________
Bloat mailing list
[email protected]
https://lists.bufferbloat.net/listinfo/bloat
