On Fri, Aug 9, 2019 at 10:49 AM Sebastian Moeller <[email protected]> wrote:
>
>
>
> > On Aug 9, 2019, at 19:44, Rosen Penev <[email protected]> wrote:
> >
> > On Thu, Aug 8, 2019 at 9:21 PM Mikael Abrahamsson <[email protected]> wrote:
> >>
> >> On Thu, 8 Aug 2019, Toke Høiland-Jørgensen wrote:
> >>
> >>> This looks like you're running sqm-scripts on a VLAN interface? Does it
> >>> make any difference if you run it on the physical eth1?
> >>
> >> Due to how the WRT1200AC is set up internally, this is the only way to do
> >> it. It's how "wan" is set up.
> > Note that OpenWrt uses its NIH swconfig to configure the switch
>
> Who knew it was the national institute of health that invented
> swconfig ;)
>
> Best Regards & only kidding
> Sebastian
>
>
> > instead of DSA. DSA might give you different results.
>
> I believe Toke's omnia might run DSA already, at least the turris OS
> 4 betas use DSA instead of swconfig, not that this has any bearing on the
> wrt1200ac...
Correct. On the Omnia, the WAN port is not connected to the switch.
It's not too relevant here.
>
> >>
> >> --
> >> Mikael Abrahamsson email:
> >> [email protected]_______________________________________________
> >> Bloat mailing list
> >> [email protected]
> >> https://lists.bufferbloat.net/listinfo/bloat
> > _______________________________________________
> > Bloat mailing list
> > [email protected]
> > https://lists.bufferbloat.net/listinfo/bloat
>
_______________________________________________
Bloat mailing list
[email protected]
https://lists.bufferbloat.net/listinfo/bloat
