[Bridge] Destination Host Unreachable

[Wes Hegge]

Hopefully this is a simple answer.  I am new to setting up bridges on a 
linux system.  Here is what I have set up:

Laptop directly connected to the eth0 port on the bridge (A Soekris 4521 
board).  The otherside of the bridge is a wirelass lan card (SMC2532b-w) 
as wlan0.  The wlan0 is setup in managed mode to communicate to my test 
ap2000.

When I do a 'brctl showmacs br0' on the bridge it shows a bunch of mac 
addresses. So, I beleive the problem of using a wireless card is not 
relevant in this case.  If I am wrong please let me know.

If I do a ping from the bridge (I can telnet into it), all packets are 
lost.  If I do a ping from the laptop, all packets are lost, but I also 
receive the message Destination Host Unreachable.

Here is the commands in the 'interfaces' file for setting up the bridge:
iface br0 inet dhcp
        bridge_ports eth0 wlan0
        pre-up ifconfig eth0 0.0.0.0 up
        pre-up ifconfig wlan0 0.0.0.0 up
        pre-up iwconfig wlan0 mode managed
        pre-up iwconfig wlan0 essid test
        pre-up iwconfig wlan0 key off
        pre-up brctl addbr br0
        pre-up brctl addif br0 eth0
        pre-up brctl addif br0 wlan0
        pre-up ifconfig br0 172.17.4.10 netmask 255.255.0.0 gateway 172.17.1.1 up
Any ideas on what I need to do to get this bridge working?
Thanks,
Wes Hegge
SignalBlast.Com, Inc.
e: [EMAIL PROTECTED]
p: (815) 397-1700
_______________________________________________
Bridge mailing list
[EMAIL PROTECTED]
http://lists.osdl.org/mailman/listinfo/bridge