Hi
Folk,
My BOX
is running Debian Sarge. i recently setup a bridge with two NIC's for
transparent proxy. However something weird i found as listed below when i run
ifconfig. So just curious to ask why the hardware address of "br0" is the
same as "eth1", it's supposed to be the same as "eth0"...normally.
Should this cause a probelm with the bridge?? If so how
can i correct the binding order?
Best
regards
Jason
[EMAIL PROTECTED]:~> ifconfig
br0 Link encap:Ethernet HWaddr 00:04:75:81:D2:1D
inet addr:10.0.3.129 Bcast:195.30.198.255 Mask:255.255.255.128
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:826 errors:0 dropped:0 overruns:0 frame:0
TX packets:737 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:161180 (157.4 Kb) TX bytes:66708 (65.1 Kb)
eth0 Link encap:Ethernet HWaddr 00:04:75:81:ED:B7
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:5729 errors:0 dropped:0 overruns:0 frame:0
TX packets:3115 errors:0 dropped:0 overruns:0 carrier:656
collisions:0 txqueuelen:100
RX bytes:1922290 (1.8 Mb) TX bytes:298837 (291.8 Kb)
Interrupt:11 Base address:0xe400
eth1 Link encap:Ethernet HWaddr 00:04:75:81:D2:1D
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:1 frame:0
TX packets:243 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:342 (342.0 b) TX bytes:48379 (47.2 Kb)
Interrupt:7 Base address:0xe800
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:1034 errors:0 dropped:0 overruns:0 frame:0
TX packets:1034 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:82068 (80.1 Kb) TX bytes:82068 (80.1 Kb)
_______________________________________________ Bridge mailing list [email protected] https://lists.osdl.org/mailman/listinfo/bridge
