Hi Dave, Oops, sorry. I forgot to mention I'm using brltty 3.10 on a fedora 11 system.
I tried to launch it from an SSH terminal as follows: brltty -e -l debug -n >From what is displayed by brltty, I can notice that the display is correctly detected and identified as a Braillex EL 66S by the Papenmeier driver. But when I move the EAB, left, right or whatever, brltty only displays: brltty: command: 000000 on the terminal. Therefore, now, I know that something happens when I move the EAB but I don't know what happens yet. Many thanks for your help. Have a nice day. ChD -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Dave Mielke Sent: jeudi 9 juillet 2009 17:26 To: Informal discussion between users and developers of BRLTTY. Subject: Re: [BRLTTY] Braillex EL 66S problem [quoted lines by Delaunay Christophe on 2009/07/09 at 16:26 +0200] >I recently acquired e new braillex el 66s Braille display from >Papenmeier. > >I successfully installed it on a windows-based PC so I can be sure that >from a hardware point of view, it works correctly. That's good to know. >Then, I connected it to the linux PC and started brltty. > >Brltty displays normally but I can't navigate through the screen. It >seems like all the functions from the so-called Easy Access Bar of my >device are unmapped. Which release of brltty are you using? _______________________________________________ This message was sent via the BRLTTY mailing list. To post a message, send an e-mail to: [email protected] For general information, go to: http://mielke.cc/mailman/listinfo/brltty
