On 6/8/14, kbenjamin Coplon <mr.g...@gmail.com> wrote: > I'm using an ALIX board with a WLM200NX as a 802.11g access point > using OpenBSD 5.5. > It works great for a while until i get "athn0: device timeout" a few > times, then it stops working until i reboot it. > The athn man page says: > " athn0: device timeout A frame dispatched to the hardware for > transmission did not complete in time. The driver will reset the > hardware. This should not happen." > > That last line makes me think i've found a bug. > > I'm sorry i don't know whether this is the right place to ask, i > didn't see any offcial OpenBSD noob list, > if this is the wrong place please point me in the right direction. > > Thank you > passstab >
I've tried fw_update which didn't help. here is dmesg " cpu0: FPU,DE,PSE,TSC,MSR,CX8,SEP,PGE,CMOV,CFLUSH,MMX,MMXX,3DNOW2,3DNOW real mem = 267943936 (255MB) avail mem = 251260928 (239MB) mainbus0 at root bios0 at mainbus0: AT/286+ BIOS, date 11/05/08, BIOS32 rev. 0 @ 0xfd088 pcibios0 at bios0: rev 2.1 @ 0xf0000/0x10000 pcibios0: pcibios_get_intr_routing - function not supported pcibios0: PCI IRQ Routing information unavailable. pcibios0: PCI bus #0 is the last bus bios0: ROM list: 0xe0000/0xa800 cpu0 at mainbus0: (uniprocessor) mtrr: K6-family MTRR support (2 registers) pci0 at mainbus0 bus 0: configuration mode 1 (bios) pchb0 at pci0 dev 1 function 0 "AMD Geode LX" rev 0x33 glxsb0 at pci0 dev 1 function 2 "AMD Geode LX Crypto" rev 0x00: RNG AES vr0 at pci0 dev 9 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 10, address 00:0d:b9:22:1f:dc ukphy0 at vr0 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063, model 0x0034 vr1 at pci0 dev 10 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 11, address 00:0d:b9:22:1f:dd ukphy1 at vr1 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063, model 0x0034 vr2 at pci0 dev 11 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 15, address 00:0d:b9:22:1f:de ukphy2 at vr2 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063, model 0x0034 athn0 at pci0 dev 12 function 0 "Atheros AR9280" rev 0x01: irq 9 athn0: AR9280 rev 2 (2T2R), ROM rev 22, address 04:f0:21:0e:84:6a glxpcib0 at pci0 dev 15 function 0 "AMD CS5536 ISA" rev 0x03: rev 3, 32-bit 3579545Hz timer, watchdog, gpio, i2c gpio0 at glxpcib0: 32 pins iic0 at glxpcib0 maxtmp0 at iic0 addr 0x4c: lm86 pciide0 at pci0 dev 15 function 2 "AMD CS5536 IDE" rev 0x01: DMA, channel 0 wired to compatibility, channel 1 wired to compatibility wd0 at pciide0 channel 0 drive 0: <SanDisk SDCFH-002G> wd0: 1-sector PIO, LBA, 1907MB, 3906560 sectors wd0(pciide0:0:0): using PIO mode 4, DMA mode 2 pciide0: channel 1 ignored (disabled) ohci0 at pci0 dev 15 function 4 "AMD CS5536 USB" rev 0x02: irq 12, version 1.0, legacy support ehci0 at pci0 dev 15 function 5 "AMD CS5536 USB" rev 0x02: irq 12 usb0 at ehci0: USB revision 2.0 uhub0 at usb0 "AMD EHCI root hub" rev 2.00/1.00 addr 1 isa0 at glxpcib0 isadma0 at isa0 com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo com0: console com1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo pcppi0 at isa0 port 0x61 spkr0 at pcppi0 npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16 usb1 at ohci0: USB revision 1.0 uhub1 at usb1 "AMD OHCI root hub" rev 1.00/1.00 addr 1 nvram: invalid checksum vscsi0 at root scsibus0 at vscsi0: 256 targets softraid0 at root scsibus1 at softraid0: 256 targets root on wd0a (72df31a55cbd4e5e.a) swap on wd0b dump on wd0b clock: unknown CMOS layout athn0: device timeout vr0: restarting athn0: device timeout athn0: device timeout # "
