On Wed, Dec 31, 2025 at 12:09:06AM +0000, Vitaliy Makkoveev wrote: > Sorry, I mean I see no errors in debug output. According log, the card > performs association, but in fact it does not:
Please send the full firmware error trace. Above "driver status" there should be lines which show firmware error details. These details include the hex code of the last command received by firmware, an important detail which is missing from this bug report. Are you able to re-configure the AP? If so, are there any settings related to management frame encryption (PMF/MFP) or WPA3 which you can change to see if this makes any difference? > driver status: > tx ring 0: qid=0 cur=54 cur_hw=54 queued=0 > tx ring 1: qid=1 cur=0 cur_hw=0 queued=0 > tx ring 2: qid=2 cur=0 cur_hw=0 queued=0 > tx ring 3: qid=3 cur=0 cur_hw=0 queued=0 > tx ring 4: qid=4 cur=0 cur_hw=0 queued=0 > tx ring 5: qid=5 cur=0 cur_hw=0 queued=0 > tx ring 6: qid=6 cur=0 cur_hw=0 queued=0 > tx ring 7: qid=7 cur=0 cur_hw=0 queued=0 > tx ring 8: qid=8 cur=0 cur_hw=0 queued=0 > tx ring 9: qid=9 cur=0 cur_hw=0 queued=0 > rx ring: cur=428 > 802.11 state SCAN > iwx0: SCAN -> INIT > iwx0: begin active scan > iwx0: INIT -> SCAN > iwx0: end active scan > iwx0: - 0a:0b:0c:0d:0e:0f 6 +13 54M ess privacy rsn! "wifi_help"! > iwx0: + 11:22:33:44:55:66 2 +42 54M ess privacy rsn "myap" > iwx0: - 1a:1b:1c:1d:1e:1f 12 +33 54M ess privacy rsn "Room"! > iwx0: firmware has detected regulatory domain 'RU' (0x5255) > iwx0: SCAN -> AUTH > iwx0: sending auth to 11:22:33:44:55:66 on channel 2 mode 11g > iwx0: AUTH -> ASSOC > iwx0: sending assoc_req to 11:22:33:44:55:66 on channel 2 mode 11g > iwx0: ASSOC -> RUN > iwx0: associated with 11:22:33:44:55:66 ssid "myap" channel 2 start MCS 0 > short preamble short slot time HT enabled > iwx0: missed beacon threshold set to 30 beacons, beacon interval is 100 TU > > $ ifconfig iwx0 > iwx0: flags=8947<UP,BROADCAST,DEBUG,RUNNING,PROMISC,SIMPLEX,MULTICAST> mtu > 1500 > lladdr aa:bb:cc:dd:ee:ff > index 1 priority 4 llprio 3 > trunk: trunkdev trunk0 > groups: wlan > media: IEEE802.11 autoselect (HT-MCS11 mode 11n) > status: no network > ieee80211: join myap chan 2 bssid 11:22:33:44:55:66 59% wpakey > wpaprotos wpa2 wpaakms psk,sha256-psk wpaciphers ccmp wpagroupcipher ccmp > >
