Hi Brian, I have never seen these lines in console logs ep93xx-eth version 0.1 loading eth0: ep93xx on-chip ethernet, IRQ 39, 00:0e:3a:11:22:33. Well I searched "ep93xx-eth" a lot in the scripts where it is loaded but I can't figure out.
I just want to Disable Network Support at boot time so that boot time can be Reduced. Then enable it again after boot. If you can provide me some more insight, that will be great. Regards, Vivek :- -----Original Message----- From: Brian Austin [mailto:[EMAIL PROTECTED] Sent: Tuesday, August 21, 2007 8:38 PM To: Vivek-Kumar Gupta Cc: [email protected] Subject: Re: disable network module at boot time That means your network subsystem drivers are loading. Not the physical Ethernet Device. For a device you should see something like this. ep93xx-eth version 0.1 loading eth0: ep93xx on-chip ethernet, IRQ 39, 00:0e:3a:11:22:33. what you are seeing is networking support, not device support. Like Packet Socket IP: tunneling and what not. On Tue, 2007-08-21 at 07:09 -0700, Vivek-Kumar Gupta wrote: > Hi Everybody, > > > > I am using busy box for embedded device. > > I am facing a peculiar problem. > > > > I want to my board to boot with network module. > > When kernel starts uncompressing, messages on console comes like > > ==== > > NET: Registered protocol family 2 > > IP route cache hash table entries: 1024 (order: 0, 4096 bytes) > > TCP established hash table entries: 2048 (order: 1, 8192 bytes) > > TCP bind hash table entries: 1024 (order: 0, 4096 bytes) > > TCP: Hash tables configured (established 2048 bind 1024) > > TCP reno registered > > .... > > > > NET: Registered protocol family 1 > > NET: Registered protocol family 10 > > NET: Registered protocol family 17 > > NET: Registered protocol family 15 > > ==== > > > > This suggests that network module is being loaded by kernel. > > I have compiled Ethernet as module. I want to enable network module > after kernel boots ( post kernel) via some script. > > I have modified the /etc/modprobe.conf, rc.sysinit so that init > process don't load network module, but this modification stopped the > network services. > > > > Can any one help me how to disable network module while kernel is > booting and enable it again after kernel boots. > > Thanks in advance. > > > > Regards, > > Vivek Kumar Gupta > > Marvell Semiconductor | 77A, IFFCO ROAD | SECTOR 18 | GURGAON - 122 > 015 | India. > > (: (Work) +91-124-4516954 | 7: (Fax) +91-124-4516970 | > *: [EMAIL PROTECTED] > > > > > _______________________________________________ > busybox mailing list > [email protected] > http://busybox.net/cgi-bin/mailman/listinfo/busybox _______________________________________________ busybox mailing list [email protected] http://busybox.net/cgi-bin/mailman/listinfo/busybox
