Hi i'm sorry for the poor quality of the test scenario of the previous mail. here below a more readable one
G3 Fax -------->FXS port of a Custom Board CW based | --------SIP-Proxy------| Custom Board CW based FXS port | ----------G3 Fax thanks a lot fabio [EMAIL PROTECTED] ha scritto: > Hi all > I'm trying to integrate CW on a custom board and to use T38Gateway > application. > The test scenario is depicted here below > > ---------------------------------------- > > ------------------------------------------- > G3 Fax -------->FXS port Custom Board CW based | > --------SIP-Proxy------| Custom Board CW based FXS port | > ----------G3 Fax > > ---------------------------------------- > > ------------------------------------------- > The Tx CallId is 207, the Rx CallId is 308. On both Callweaver PBX > T38gateway has been used to handle the call (Tx and Rx side). > In the test done the fax has been sent from 207 to 308. > The G3 Fax are a couple of analog modems connected to PC > I have attached both a capture of the network traffic sniffed and the > log taken from Callweaver > My feeling is that the SIP sessions has been established correctly and > the switchover happen succesfully. Anyway when the couple of CW try to > exchange some T38 packet, some error occurs and the fax transmission > fails. I cannot see the training sequence, but many fcs-bad packet have > been transmitted by both sides. Please help me to understand better what > happens and where is the problem. could be an endianess problem? my CPU > is a bi endian architecture. > > best regards > > fabio antonini > > Kasko Networks S.r.l. > Piazza Regina Margherita > 67100 L'Aquila (IT) > > _______________________________________________ > Callweaver-users mailing list > [email protected] > http://lists.callweaver.org/mailman/listinfo/callweaver-users > > > _______________________________________________ Callweaver-users mailing list [email protected] http://lists.callweaver.org/mailman/listinfo/callweaver-users
