> I'm getting a ROACH2 rev2 to power on automatically when A/C power is 
> applied. is it normal?
There are two jumpers for this:

"JP2 -- AUTO_START" will soft power the board on normally when AC is applied. 
In this case, if there's a HW fault the board will shut itself off safely (eg 
faulty power supply, over-temperature FPGA etc). The onboard power button 
should still function normally (press it to turn the board off). This is normal 
shipping configuration. If you don't want this behaviour, remove the jumper 
(it's right next to the ATX power connector). If removed, the board will stay 
in the standby state when AC is applied, and only turn on when you press the 
front panel button.

The other jumper (JP1 -- PWR_OVERRIDE) will force the board to turn on 
no-matter-what, whenever there's AC present. This overrides the HW protection 
circuitry and the power button. This one is a little dangerous -- don't put a 
jumper on here unless you're sure you want this behaviour (mostly only used for 
debugging faulty power circuits).

Jason



Reply via email to