No, I'm using the tutorial version. That might be the problem. However I'm 
reluctant to update since this might cause incompatibilities with my previous 
models. I suppose that if I what to use the DRAM I don't have other choice. Do 
you have any suggestions?

Many thanks,

Franco

---- Jason Manley wrote ----

>Are you running the latest version of the toolflow? Earlier versions did not 
>include the CPU interface to the DRAM.
>
>Jason
>
>
>On 02 Dec 2016, at 15:30, Franco <[email protected]> wrote:
>
>> The register is not present in the bitstream. I thought that the register 
>> was inside the dram yellow block though. I have to add it manually or 
>> something?
>> 
>> Here is the listdev just in case:
>> 
>> ['acc_len',
>> 'adc5g_controller',
>> 'cnt_rst',
>> 'dout0_0',
>> 'dout0_1',
>> 'dout0_2',
>> 'dout0_3',
>> 'dout1_0',
>> 'dout1_1',
>> 'dout1_2',
>> 'dout1_3',
>> 'dout2_0',
>> 'dout2_1',
>> 'dout2_2',
>> 'dout2_3',
>> 'filter_gain',
>> 'filter_on',
>> 'snapshot0_bram',
>> 'snapshot0_ctrl',
>> 'snapshot0_status',
>> 'snapshot0_trig_offset',
>> 'snapshot1_bram',
>> 'snapshot1_ctrl',
>> 'snapshot1_status',
>> 'snapshot1_trig_offset',
>> 'sync_gen_sync',
>> 'sync_gen_sync_period_sel',
>> 'sync_gen_sync_period_var',
>> 'sys_board_id',
>> 'sys_clkcounter',
>> 'sys_rev',
>> 'sys_rev_rcs',
>> 'sys_scratchpad',
>> 'write_done']
>> 
>> thanks,
>> 
>> Franco
>> 
>> 
>> On 02/12/16 10:02, Marc Welz wrote:
>>> Then there is no bitstream programmed or the particular bitstream
>>> doesn't contain that register. Type
>>> 
>>> ?listdev
>>> 
>>> on that connection to find out
>>> 
>>> regards
>>> 
>>> marc
>>> 
>>> 
>>> On Fri, Dec 2, 2016 at 12:52 PM, Franco <[email protected]> wrote:
>>>> It says: #log error 1018802834854 raw
>>>> register\_dram_controller\_not\_defined
>>>> 
>>>> 
>>>> Franco
>>>> 
>>>> 
>>>> 
>>>> On 02/12/16 04:32, Marc Welz wrote:
>>>>> telnet to the roach on port 7147 while repeating the operation - what
>>>>> do the #log messages say ?
>>>>> 
>>>>> On Thu, Dec 1, 2016 at 3:43 PM, Franco <[email protected]> wrote:
>>>>>> Hi!
>>>>>> 
>>>>>> I tried to test the dram of ROACH2 by porting an example model I had for
>>>>>> ROACH1.
>>>>>> 
>>>>>> However when I tried to read the dram I got the following error:
>>>>>> 
>>>>>> RuntimeError: Request write failed.
>>>>>>    Request: ?write dram_controller 0 \0\0\0\0
>>>>>>    Reply: !write fail.
>>>>>> 
>>>>>> Someone knows what's the problem?
>>>>>> 
>>>>>> 
>>>>>> thanks,
>>>>>> 
>>>>>> Franco Curotto
>>>>>> 
>>>>>> 
>> 
>> 
>

Reply via email to