Hi James

Thanks for the help!! I had to add software registers to en0 and en1 as
well but know it compiles.

Thanks for the help!!

I really apreciate it

Heystek

On Mon, May 8, 2017 at 2:23 PM, James Smith <[email protected]> wrote:

> Hello Heystek,
>
> The KatADC is described here:
> https://casper.berkeley.edu/wiki/KatADC
>
> It's got two channels which you need to enable if you want to use them,
> and 31.5 dB variable attenuators which you need to set.
>
> So if you want them to be on all the time, just hard-wire some 1s into en0
> and en1. I'd suggest putting software registers into atten0 and atten1 then
> writing to them from a Python script. You can adjust the attenuation from 0
> dB to 31.5 dB in 0.5 dB increments using a 5-bit number.
>
> Regards,
> James
>
>
>
> On Mon, May 8, 2017 at 2:17 PM, Heystek Grobler <[email protected]>
> wrote:
>
>> Good day everyone
>>
>> I have a ROACH1 board with a katadc. I have located the katadc under the
>> CAPER XPS Blockset (I am trying to do tut3). I have swapped the iadc for
>> the katadc.
>>
>> The problem is, the katadc has the following inputs:
>> en0
>> atten0
>> en1
>> atten1
>>
>> I need to connect something to those inputs to be able to compile a bof
>> file. Does anyone perhaps know what inputs I should connect/use?
>>
>> Have a great day
>>
>> Thanks for the help
>>
>> Heystek Grobler
>>
>>
>> --
>> You received this message because you are subscribed to the Google Groups
>> "[email protected]" group.
>> To unsubscribe from this group and stop receiving emails from it, send an
>> email to [email protected].
>> To post to this group, send email to [email protected].
>>
>
>

-- 
You received this message because you are subscribed to the Google Groups 
"[email protected]" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To post to this group, send email to [email protected].

Reply via email to