Hi Michael

In the HIPSR system (https://arxiv.org/abs/1702.00443) we use the GPIO on a
ROACH1 to control the noise diode on the Parkes 64m, so definitely not a
bad venture! 0.5 Hz should not pose any difficulties.

I would expect to measure closer to 5V (50 ohm terminated), but haven't
used the ROACH2 GPIO.

Cheers
Danny

On Thu, May 11, 2017 at 11:10 AM, Michael D'Cruze <
[email protected]> wrote:

> Dear all,
>
>
>
> I’m planning to use a 0.5Hz square wave, generated from the FPGA and
> output via sync_out, to eventually fire our cal diode (via much cabling). A
> quick hardware test today shows the sync_out port driving at circa 7V (!).
> This is a bit higher than I was expecting. Does this venture as a whole
> seem like a particularly bad idea to anyone with experience using sync_out?
> Is this output voltage roughly as expected?
>
>
>
> Thanks a lot,
>
> Michael
>
> --
> You received this message because you are subscribed to the Google Groups "
> [email protected]" group.
> To unsubscribe from this group and stop receiving emails from it, send an
> email to [email protected].
> To post to this group, send email to [email protected].
>



-- 
Danny Price | [email protected] | +1 617-386-3700

-- 
You received this message because you are subscribed to the Google Groups 
"[email protected]" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To post to this group, send email to [email protected].

Reply via email to