I assume you're trying to clock an ADC, which will in turn clock the FPGA? 

Most CASPER ADCs and DACs need a 0dBm signal for the clock, but can usually 
accommodate a few dB around that figure.

See for example:
https://casper.berkeley.edu/wiki/ADC2x1000-8
https://casper.berkeley.edu/wiki/ADC1x3000-8
https://casper.berkeley.edu/wiki/KatADC

Jason


On 25 May 2017, at 14:21, James Smith <[email protected]> wrote:

> Hello Heystek,
> 
> Yes, a sin-wave (usually called CW or continuous wave signal) is the ideal 
> thing to do. I use 800 MHz on a ROACH1, though I understand that they can go 
> a bit higher. Other more experienced users might be able to comment more.
> 
> My particular setup is: valon synth inside the ROACH's box, 10 MHz reference 
> signal from the station's timing and frequency ref.
> The valon then generates an 800 MHz from that which I put into a KatADC's 
> "clk" port.
> The "sync" port is for a 1PPS signal.
> 
> Regards,
> James
> 
> 
> On Thu, May 25, 2017 at 2:18 PM, Heystek Grobler <[email protected]> 
> wrote:
> Hi everyone 
> 
> Does anyone know what is the best clock signal for a ROACH1 and ROACH2 board 
> and will a sign wave do and at what level?
> 
> Thanks for all the help
> 
> Heystek
> 
> -- 
> You received this message because you are subscribed to the Google Groups 
> "[email protected]" group.
> To unsubscribe from this group and stop receiving emails from it, send an 
> email to [email protected].
> To post to this group, send email to [email protected].
> 
> 
> -- 
> You received this message because you are subscribed to the Google Groups 
> "[email protected]" group.
> To unsubscribe from this group and stop receiving emails from it, send an 
> email to [email protected].
> To post to this group, send email to [email protected].

-- 
You received this message because you are subscribed to the Google Groups 
"[email protected]" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To post to this group, send email to [email protected].

Reply via email to