Hi Tony, the initial u-boot is transferred using x-modem. This is done via
serial link. If you have a minicom session open there will be a com port
clash. Try again with minicom closed.

Regards
Alec

PS. I'll go take a look at the code and see what else could be wrong but I
think it's just a com port clash.

On Mon, Jun 12, 2017 at 6:09 AM, Tony Goodson <[email protected]> wrote:

> Hello,
>
> New member here.
>
> At the University of Washington, we've been running a pair of ROACH2's
> successfully for several years.
>
> However, today I was restarting one of them through the roach2_ats.py
> utility, and u-boot appears to be failing.  I inadvertently unloaded U-boot
> (option m), and subsequently tried to load u-boot. (option 0).
>
> The symptoms/behavior:
> I can turn the board on and off via roach2_ats.py, but uboot doesn't start
> - I see no traffic across my minicom terminal associated with the u-boot.
>
> I can succesfully run an unload U-boot (or at least no errors are reported
> back from roach2_ats.py). When I try to run a "load U-boot, kernel, and
> filesystem", I get an error that says "device reports readiness to read but
> returned no data (device disconnected or multiple access on port?)".  While
> doing this, I get some odd symbols on the minicom terminal.  Also, if I run
> option 9 ("Test FLASH and PPC DDR2 memory"), I see the following on the
> minicom terminal:
>
> "start
> eeeeeeeeee
> wwwwwwwwww
> rrrrrrrrrr
> pass"
>
> Any help would be greatly appreciated.
>
> Also, if you could please add me to the list server - when I try to join
> via the link at the casper site, I get to a Berkeley Calnet login.
>
> Thanks in advance,
>
> --Tony Goodson
>
> --
> You received this message because you are subscribed to the Google Groups "
> [email protected]" group.
> To unsubscribe from this group and stop receiving emails from it, send an
> email to [email protected].
> To post to this group, send email to [email protected].
>

-- 
You received this message because you are subscribed to the Google Groups 
"[email protected]" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To post to this group, send email to [email protected].

Reply via email to