Hi all,
Thank you Jack for your reply I followed your advice and tested the one_gbe
"yellow block". It does not give me an error in the compilation but it does
in the synthesis using XPS.
At the beginning of the compilation it says that:












*############################### Block objects creation
###############################misc_ports =        app_clk: {[1]  'in'
'sys_clk'}    mac_tx_rst: {[1]  'in'
'one_geb_xb_one_GbE_app_tx_rst'}misc_ports =        app_clk: {[1]  'in'
'sys_clk'}    mac_tx_rst: {[1]  'in'  'one_geb_xb_one_GbE_app_tx_rst'}
mac_rx_rst: {[1]  'in'  'one_geb_xb_one_GbE_app_rx_rst'}*

and after a while it gives the following error:














*Error found in mapping process, exiting...Errors found during the mapping
phase.  Please see map report file for moredetails.  Output files will not
be written.Design Summary--------------Number of errors   :  86Number of
warnings :   4ERROR:Xflow - Program map returned error code 2. Aborting
flow execution...gmake: *** [__xps/system_routed] Error 1ERROR:EDK -
Error while running "gmake -f system.make bits".: XPS failed.*

Any idea what I could be doing wrong?
Has anyone worked with that "yellow block" recently?
Is there any example available?
Thank you,
XB




On Mon, Jun 19, 2017 at 4:43 PM Jack Hickish <[email protected]> wrote:

> Hi Xavier,
>
> The ROACH2 (unlike the ROACH1) has a dedicated 1GbE connection straight to
> the FPGA fabric -- it's the "other" RJ45 connector in addition to the one
> you're using to talk katcp. You can access it using the one_gbe yellow
> block -- I think this is probably the way to go.
>
> Cheers
> Jack
>
> On Mon, 19 Jun 2017 at 16:39 Xavier Bosch <[email protected]>
> wrote:
>
>> Hi,
>>
>> I have a system that generates ~100 Mbit/s data throughput in a ROACH2
>> board.
>>
>> Until now I have been using the KATCP and software registers to read
>> those values at a much smaller data rate. The only option that I found in
>> the documentation to use the design at full resolution are the 10 GbE
>> boards, that we already have in hand. The 10 GbE boards look to me that is
>> a little overkill for what I would like to do. Is there any other method to
>> get data out from a ROACH2 board faster than the software register but
>> slower than the 10 GbE boards?
>>
>> I am thinking in something like an USB 2.0 port (max 480 Mbit/s) or a
>> 1GbE connection.
>>
>> Thank you,
>> XB
>>
>>
>> --
>> You received this message because you are subscribed to the Google Groups
>> "[email protected]" group.
>> To unsubscribe from this group and stop receiving emails from it, send an
>> email to [email protected].
>> To post to this group, send email to [email protected].
>>
>

-- 
You received this message because you are subscribed to the Google Groups 
"[email protected]" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To post to this group, send email to [email protected].

Reply via email to