Dave,

The SNAP image mentioned should be a unTARed as stated and be ready to burn on 
an SD card.


tar -xzvf rpi_snap.img.tar.gz

This command should give you a file rpi_snap.img ready to burn to an SD card.


Typically, after downloading a Pi image you copy the image directly to a mini 
SD card. You can do this using a linux computer or a Mac. If the SNAP image was 
created using the dd command it should be copied back to a SD card in the same 
manner.

First you have to make sure you know which disk the SD card is located on your 
system. The SD card should be formatted with a FAT filesystem and then be 
un-mounted.

You may use the Disk Utility on a Mac to format and umount the disk. There are 
other utilities in Linux to do this as well.

This command will copy the image from (if) to (of):

sudo dd bs=1m if=./Name_of_Image_Download.img of=/dev/diskX

You must be sure to only copy to the disk with the SD card or you may damage 
your file system. Make sure you know your disk assignments. Move to the 
directory that contains the image before running the dd command.

After copying the image to an SD card which takes a while (30 minutes to an 
hour estimate) you can put the card in the Pi and with it connected to a HDMI 
monitor power up the Pi and watch it boot up. With a standard Pi image use a 
USB keyboard and Mouse. You will then have to configure the pi. Typically allow 
ssh connections and install xrdp, set the time zone and allow vnc connections. 
IF you have a preconfigured SNAP image you may be able to skip this step.

Run ifconfig to determine the Pi ip address and mac address. You can set this 
to be static in the Pi or force it on your router.





Bob Stricklin


On Oct 19, 2018, at 1:20 PM, David Marsh 
<[email protected]<mailto:[email protected]>> wrote:

Hello,

We are trying to setup the SNAP board using the instructions found at 
https://casper.berkeley.edu/wiki/SNAP_Bringup.

We are using a Raspberry Pi 3 B+ and we are trying to configure it using the Pi 
3 image. When we download the image we are unable to unzip the file and the 
extracted image is not valid. We were wondering if this was a corrupted image. 
Is there another working image? We tried unzipping the download on multiple 
machines/operating systems.

Thanks,
David



--
You received this message because you are subscribed to the Google Groups 
"[email protected]<mailto:[email protected]>" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to 
[email protected]<mailto:[email protected]>.
To post to this group, send email to 
[email protected]<mailto:[email protected]>.

-- 
You received this message because you are subscribed to the Google Groups 
"[email protected]" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To post to this group, send email to [email protected].

Reply via email to