Hi Franco,

In addition to Dave's advice-- how are you configuring your board? After
programming the FPGA, you'll need to appropriately configure the ADC to
operate in the right mode. The code seems to be linked here --
https://casper.ssl.berkeley.edu/wiki/ADC16x250-8_coax_rev_2

Cheers
Jack

On Wed, 3 Apr 2019 at 00:53, Franco <[email protected]> wrote:

> Hi Casperites,
>
> I'm working in some project that uses a ROACH2 and an adc16x250-8 ADC
> board. When I check the raw data from the ADC using a snapshot block I see
> this weird effect where two consecutive samples have always the same value,
> as shown in this image:
>
> https://my.pcloud.com/publink/show?code=XZMRx67Zpj7XjnkE5PypVuuDCB9Mhu8IJJ37
>
> According to an ex-coworker, this is the expected behavior of the
> adc16x250-8 board in 16 input mode, because of some constraints in the
> communication between the ADC and the FPGA, the FPGA must run at twice the
> speed to correctly receive the sampled data. However, couldn't find any
> explicit mention of this phenomenon in the CASPER website or mailing list.
> Can someone confirm this is the correct behavior so I can get peace of mind
> :)?
>
> Some info of my test:
> - Board: ROACH2-rev2
> - ADC: ADC16x250-8 coax rev2
> - ADC mode: 16 inputs (demux 1, using David Macmahon initalization code)
> - User IP Clock Rate: 140 MHz
> - Actual clock frequency used in the adc board: 140MHz
>
> Thanks,
>
> Franco Curotto
>
> --
> You received this message because you are subscribed to the Google Groups "
> [email protected]" group.
> To unsubscribe from this group and stop receiving emails from it, send an
> email to [email protected].
> To post to this group, send email to [email protected].
>

-- 
You received this message because you are subscribed to the Google Groups 
"[email protected]" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To post to this group, send email to [email protected].

Reply via email to