The ZCU216 has a 4 x 25.7 cage for a CAUI-4.   In order to receive jumbo 
frames at a receiving NIC that only has 100GbE ports,  what kind of 
hardware cable work would be appropriate?

I have attempted to work closely with a hardware manufacturer, but I feel 
they are unreliable in their "advice".  They sent detailed results of a 
connection test of their own cable, allegedly proving that their hardware 
is appropriate for my use case. But they clearly implemented a single 
25GBASE-CR connection over a single port of a network switch, which then 
addressed a single device on the receiving side (enp1s0f0) . Their 
receiving NIC was set to 4x25 port configuration, making it even less 
relevant.  I post this question here as a last resort, not a first resort 
for this ongoing problem. 

Lacking a ZCU216 and its FPGA, the tech support specialists used a network 
switch as a substitute. Here is the list of the ports on their switch from 
their results. (truncated for space)

```
FS#show interfaces status

Interface                                Status    Vlan   Duplex   Speed     
Type  

---------------------------------------- --------  ----   -------  --------- 
------

TenGigabitEthernet 0/1                   down      1      Unknown  Unknown   
fiber

.

.

.

TenGigabitEthernet 0/30                  down      1      Unknown  Unknown   
fiber

TFGigabitEthernet 0/21                   up        1      Full     25G       
fiber

TFGigabitEthernet 0/22                   down      1      Unknown  Unknown   
fiber
.
.
.
```

Ethtool for their single network device shows 25GBASE-CR. 
```

Settings for enp1s0f0:

                Supported ports: [ FIBRE ]

                Supported pause frame use: Symmetric

                Supports auto-negotiation: Yes

                Supported FEC modes: None                RS           BASER

                Advertised link modes:  10000baseT/Full

                                        25000baseCR/Full

                Advertised pause frame use: No

                Advertised auto-negotiation: Yes

                Advertised FEC modes: None                RS           BASER

                *Speed: 25000Mb/s*

                Duplex: Full
```

But 25BASE-CR is not CAUI-4.   I conclude this test is therefore useless 
for this network configuration.  Your thoughts?  



-- 
You received this message because you are subscribed to the Google Groups 
"casper@lists.berkeley.edu" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to casper+unsubscr...@lists.berkeley.edu.
To view this discussion on the web visit 
https://groups.google.com/a/lists.berkeley.edu/d/msgid/casper/f8097049-e5c6-4a30-89b1-832aed2dda5an%40lists.berkeley.edu.

Reply via email to