Plus any real truck driver makes sure they are loading his truck properly. In 
the years that I was hauling I never let them load any other way then how i 
wanted it. Once it was on my truck I was responsible for it's safety

Sailor Chef <[EMAIL PROTECTED]> wrote:    P {   PADDING-RIGHT: 0px; 
PADDING-LEFT: 0px; PADDING-BOTTOM: 0px; MARGIN: 0px; PADDING-TOP: 0px  }  BODY 
{   FONT-SIZE: 10pt; FONT-FAMILY: Tahoma  }        Having worked for a builder 
who shipped several boats by truck and having worked in a boatyard where boats 
were picked up and delivered by truck on a regular basis. 
  All the drivers would closely monitor the loading to make sure there were no 
potential problems because once they "crossed the curb" they were responsible.
  I would suggest that, unless you signed a document specifically absolving the 
trucking co. from responsibility, get a lawyer, he has (or should have) 
insurance!
  Damage to the keel sump area will cause most insurance co.'s to total the 
boat due to the liabilities involved. If the repair does not hold and the boat 
sinks and takes you and your family with it, whether the repair was responsible 
or not, they look at buying you a new boat as cheap. 
  Mark, "Gratis" (6115) and others 
  Want to keep your WHOLE PAYCHECK?
PLEASE VISIT http://www.fairtax.org
    ----- Original Message ----- 
  From: [EMAIL PROTECTED] 
  To: [email protected] 
  Sent: Thursday, August 02, 2007 4:58 PM
  Subject: RE: catalina27-talk: Perplexing keel problem after long distance 
hauling
  

  Listees,
   
  I want to thank all of you for your thoughts regarding my keel problem. The 
damage to my boat was certainly caused by the hauler, although he claims that 
once a boat is lashed down on the flatbed, it cannot move, not even the 
slightest, so therefore he is not responsible for anything that happened. It 
doesn't seem like he has a good sense of physics. He blames any problems either 
on those who put the boat on the trailer or on those who removed it. He wants 
to claim that he has no responsibility or control over loading or unloading, 
but this makes no sense whatsoever. Is there anyone out there with a sense of 
how this works?
   
  I was able to take some of the pressure off the aft end of the keel today by 
lifting it some on the stands. The keel is only blocked on the extreme forward 
end now. As a result the crack is a bit wider. 
   
  thanks, all,
   
  Jon
    
  -----Original Message-----
From: [email protected] [mailto:[EMAIL PROTECTED] On Behalf Of 
michael mcvey
Sent: Thursday, August 02, 2007 2:24 PM
To: [email protected]
Subject: RE: catalina27-talk: Perplexing keel problem after long distance 
hauling


Sorry I did not read the full post before, I would not attempt anymore repairs 
until I spoke with my insurance agent and a surveyor or a qualified boat yard 
with a good rep. from what I have read in the other posts you have received 
some real good advice and for the hull to crack like that there is most likely 
something that is hidden. I am very practiced with fiberglass repair and this 
sound to be a little tough. From all accounts though this does sound as if the 
hauler is solely responsible for the damage and I would be in touch with 
whoever takes their claims. Best of luck
 
Mike M




    
---------------------------------
  From: [EMAIL PROTECTED]
To: [email protected]
Subject: catalina27-talk: Perplexing keel problem after long distance hauling
Date: Wed, 1 Aug 2007 22:56:29 -0400

    Listees:
   
  I have a serious but perplexing problem resulting from the long-distance haul 
of my 1975 C-27. I need your advice.
   
  The boat was hauled from North Carolina to Boston in mid-July, essentially a 
return home for the boat and for us. Somewhere along the way the boat was 
damaged. When the boat arrived it was lifted off the flatbed and put in the 
water. It immediately began to take on water--lots of it. After taking it out 
of the water, we discovered a crack at the extreme aft end of the keel at the 
hull (at the point where the hull begins to curve down to shape the narrow end 
of the keel--perhaps an inch or two down that curve). The crack was only 
several inches long around that aft end, perhaps four inches long in all, sort 
of shaped like a "u". The leak showed at the inside at the extreme aft end of 
the bilge in the passage (under the interior deck) between it and the engine 
compartment (boat has an A-4). While the pump kept on top of the leak, it did 
so only barely.
   
  A few words about the delivery: The boat had been located on the extreme aft 
end of the trailer. A power boat was placed on the front. The inside of the 
boat was an absolute mess. Things that I had carefully stowed were strewn about 
the boat. Items stowed deep in the after quarter berth were all over the salon 
floor in the forward part of the boat. It was an amazing sight that got worse 
when the water seeped up from the bilge. Clearly the boat had a very rough trip.
   
  When the boat was first on stands, I was able to ply out some resin from the 
hull crack and thought maybe I could make a temporary patch to get it across 
Dorchester Bay to my yacht club. I used Marine Tex. The fix looked good, but as 
soon as the hydraulic trailer begin to lift it from the stands and blocks, it 
cracked with a "snap." It had returned. After a short haul on a hydraulic 
trailer to the club, I removed the broken Marine Tex, opened the crack up as 
best I could, and we used West (resin, filler) and some cloth and fashioned a 
repair. When it was sealed on the outside, using a flashlight, I was able to 
locate what seemed to be a crack of sorts in the bilge in that passage leading 
to the engine compartment, where it seemed the water had come in. I poured 
resin into it, hoping it would seep down. 
   
  Today, when we lifted the boat off the stands to put it in the water, the 
same thing happened, a snap, and then a 1/8 in wide, several inch long crack 
appeared. This work was done by someone with a great deal of experience using 
West resins.
   
  What is going on? The bilge looks fine. Four years ago, I employed the 
Catalina Direct keel bolt upgrade and installed ss lags. I did this only as a 
precaution because the original bolts looked, well, rusted, but no worse than 
other Catalinas. My bilge has always been clean and dry. I see nothing amiss 
there now. There is no Catalina smile on this boat an no other external 
indications of a problem anywhere along the keel.
   
  Jon
  C-27 1858
   
   

  
---------------------------------
  PC Magazine’s 2007 editors’ choice for best web mail—award-winning Windows 
Live Hotmail. Check it out!     
---------------------------------
    
No virus found in this incoming message.
Checked by AVG Free Edition. 
Version: 7.5.476 / Virus Database: 269.11.0/927 - Release Date: 7/30/2007 5:02 
PM


       
---------------------------------
Park yourself in front of a world of choices in alternative vehicles.
Visit the Yahoo! Auto Green Center.

Reply via email to