Re: [OSL | CCIE_RS] Frame-Relay P2P

[Scott Morris]

If you're connecting two 2500 series devices back to back, you'll need a clock rate on the DCE side.  In addition, if you aren't using a frame switch in the middle, you'll want to do "no keepalive" on both serial links.   As a note, in your configs below, those interface types aren't what you'd see on a 2500.  :)     Scott Morris, CCIE4 (R&S/ISP-Dial/Security/Service Provider) #4713, JNCIE #153, CISSP, et al. CCSI/JNCI IPExpert CCIE Program Manager IPExpert Sr. Technical Instructor [EMAIL PROTECTED] http://www.ipexpert.com     From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Jamie Costabilo Sent: Wednesday, June 21, 2006 4:09 PM To: ccie_rs@onlinestudylist.com Subject: [OSL | CCIE_RS] Frame-Relay P2P Here is a quick config highlighting the frame-relay portion for on of the e-scenarios.  I am connecting two 2500 routers via a DTE/DCE serial cable.  The issue that I am running into is that the line comes up for a few seconds and then the serial interface goes down on the DTE side.  When I issue a show frame-relay pvc command, the DLCI shows as being deleted.  Am I missing something?  I was able to get it to work for a few minutes the other day but not since then.  Thanks, Jamie   R2   int s0/1/0 no ip encap frame-relay no shut   int s0/1/0.25 point-to-point ip add 192.1.25.2 255.255.255.0 frame-relay interface-dlci 205   int s0/2/0 no ip add shut clockrate 2000000   int e1/0 no switchport ip add 192.1.12.2 255.255.255.0     R5   int s0/1/0 no ip encap frame-relay no shut   int s0/1/0 point-to-point ip add 192.1.25.5/28 frame-relay interface-dlci 502