|
The message below seems to say that r2 has
no updates to send to r1. A few basics to check, do you have the neighbor
statements on both of the routers correctly configured? Are you receiving
updates on r1 from r2? You should be seeing some updates on that end as well
(every 30 seconds). Do you have the RIP configs for each? Is
the route continually appearing and timing out, or just times out for good after
the passive interface command?
From:
[EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On
Behalf Of Lloyd Ardoin I am in the middle of section 18 in WB 8.0 and am having a problem
I cannot seem to resolve between router 1 and router 2 running Rip v2. Based on
the comments I should be seeing the 150.100.35.0 network in R2’s routing
table but I am not. Per the instructions I have changed the primary and
secondary addresses to make OSPF work and added the no validate-update-source
under the Rip process on both R1 and R2 with the passive-interface command for
the appropriate interfaces and neighbor statements. Once I add the
passive-interface command under R1 along with the neighbor statement the
150.100.35.0 route will eventually time out on R2 and I am getting a message on
R2 – (when I run debug ip rip events) *Jul 23 22:26:06.443: RIP: sending v2 update to 150.100.36.1
via FastEthernet0/0 (150.100.36.2) - suppressing null update which I cannot find any information on and may be
irrelevant. When you set up Rip v2 to unicast with the passive-interface
and neighbor command should there be any type of output you can monitor in
debug to watch for errors? Can someone please help? Thanks in advance,
|
- [OSL | CCIE_RS] WB 8.0 Section 18 GRE Tunnels Lloyd Ardoin
- Re: [OSL | CCIE_RS] WB 8.0 Section 18 GRE Tunnels Michael Senno
