Hi Andy Well I am not sure ether but the "alias configure conf t" will not work on any or my routers. Below is a list of alias commands that do work all except the first one. just past them in under the global config prompt. Use the word after the exec;
alias configure conf t alias exec pvc show frame pvc alias exec map sh fram map alias exec route sh frame route alias exec sir Show IP route alias exec sii Show IP Interface Brief alias exec soi Show ip ospf interface alias exec son Show IP OSPF Neighbor alias exec sr Show Running-config alias exec sfm show fram map alias exec b sh ip int brief alias exec c conf t alias exec i sh ip route alias exec al sh frame route alias exec cc clear counter alias exec pro sh ip prot alias exec sf show frame alias exec sio sho ip ospf alias exec cib clear ip bgp alias exec ipx show ipx route alias exec ipxs show ipx servers alias exec bs show ip bgp summary alias exec bg show ip bgp alias exec sib show ip bgp alias exec sibs show ip bgp summaryc Tim Zufelt Network IDS/IPS Specialist IBM Global Services 303-924-4826 tie-line: 263-4826 Pager 1-800-759-8888 ID 1064457 "Andy LaPorte" <[EMAIL PROTECTED]> Sent by: [EMAIL PROTECTED] 04/06/2007 05:13 PM To <[email protected]> cc Subject [OSL | CCIE_RS] alias question I have a question about the alias command. I was doing a lab that required you to create two shortcuts: sir = show ip route sib = show ip interface brief The answer according the book was: alias configure sir show ip route alias configure sib show ip interface brief I’m thinking this is incorrect. The only way I could do this was to do: alias exec sir show ip route alias exec sir show ip interface brief If someone could confirm this I would be greatful. Also does anyone know if the is an errata doc for ipexpert books? Andy
