So I'm pretty much certain I found the answer to this
question through reading CISCOUNIVERCD.
But the ask in this lab:
"Make sure that either switch could be replaced with a
non-cisco switch."
I admit it threw me off a bit cause I immediately
started thinking about 802.1q vs ISL
The PG was looking for you to not use PAGP.
So is this config correct?
Cat1
interface GigabitEthernet0/1
switchport trunk encapsulation dot1q
switchport mode trunk
It says here "switchport mode trunk" ...
Does that mean the default mode is LACP?
Usually we are used to be asked in these labs to take
a group of interfaces and do a L2 trunk over and
etherchannel and we usually use "channel-group x mode
on" somewhere in the config.
CISCOUNIVERCD says:
"on Forces the interface to channel without PAgP.
With the on mode, a usable EtherChannel exists only
when an interface group in the on mode is connected to
another interface group in the on mode."
??
____________________________________________________________________________________
Be a better friend, newshound, and
know-it-all with Yahoo! Mobile. Try it now.
http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ
