YOu can find about it on cisco's web site. Also, you can take a look at page number 382 in CCIE routing switching guide third edition by wenell odom. Also, you can try it practically using dynagen.
Suresh On Thu, May 15, 2008 at 9:46 AM, aman sharma <[EMAIL PROTECTED]> wrote: > Hi Suresh, > > R u sure about this -"when BGP is used with ospf, they > bothneed to have the same router-id or else you will > have BGP synchronizatin problem". > > Thanks, > > Aman > > > --- Suresh Mishra <[EMAIL PROTECTED]> wrote: > >> One more thing to remember about router - id is that >> they do not have >> to be routable in the network. In that sense you can >> use any IP >> address as the router-id as they are used to just >> identify the router. >> >> However, as pointed out by Matt, when BGP is used >> with ospf, they both >> need to have the same router-id or else you will >> have BGP >> synchronizatin problem. >> >> On Thu, May 15, 2008 at 2:18 AM, Matt Hill >> <[EMAIL PROTECTED]> wrote: >> > Be careful with router-ids. I like to use a real >> IP on the router. >> > This way you can be guaranteed it is unique. It >> matters more for OSPF >> > than it does for anything else but for >> consistency's sake I would make >> > them all real loopbacks on the router. The same >> loopback too (unless >> > scenario dictates otherwise). >> > >> > Cheers, >> > Matt >> > >> > On 15/05/2008, khalid aljorf <[EMAIL PROTECTED]> >> wrote: >> >> Greetings all, >> >> The Q is that do i have to set the BGP router ID >> under the BGP process to be >> >> the same as the interface loopback which is used >> to establish the >> >> connectivity >> >> in "neighbor a.b.c.d update source lo0"?? or it >> can be any ID like 1.1.1.1 >> >> or 2.2.2.2 ?? >> >> >> >> kindly assist >> >> >> > >> > > > > Check out the all-new face of Yahoo! India. Go to http://in.yahoo.com/ > >
