Some hope, you can try neighbor disable-connect-check
On Tue, 10 Jun 2008 20:02:02 -0700 (PDT), "Carlos Valero" <[EMAIL PROTECTED]
hoo.com> said:

  Hi,
  I had forgotten to ask you a question about ebgp-multihop.
  Since this issue was raised, this question came back to my mind.
  This is about BGP Lab 7 (v9.0).  I know you don't have v9.0
  anymore, but this should not be too complicated for you.
  One of the initial tasks was to configure R1 on AS 100 and R2 on
  AS 200, but peering with R1's loopback.
  Of course we need to use ebgp-multihop in this case.  But while I
  was expecting to see "ebgp-multihop 2", the actual solution used
  "ebgp-multihop 3"
  I tried "ebgp-multihop 2" just to see, but of course it did not
  work!
  But I'm not sure why.
  If they were peering using a Serial Link, then "ebgp-multihop 2"
  would be OK; I know that.
  But in this case R1 and R2 are connected through Switch 1 on VLAN
  12.
  Does the Switch count as an additional hop?
  If that's the case, is it because the Switch is acting as Layer 3
  device?
  What if the switch was a pure Layer 2 device, with no VLAN?
  Would I still need "ebgp-multihop 3"  instead of "ebgp-multihop
  2" ?
  --- On Tue, 6/10/08, Scott Morris <[EMAIL PROTECTED]> wrote:

    From: Scott Morris <[EMAIL PROTECTED]>
    Subject: Re: [OSL | CCIE_RS] EBGP Multihop
    To: "'OSL CCIE Routing and Switching Lab Exam'"
    <[email protected]>
    Date: Tuesday, June 10, 2008, 3:32 PM

  It's mandatory to have reachability.  :)   However you choose to
  do that in order to build your session is between you and your
  lab requirements!

  But no reachability = no bgp session!

  HTH,

  Scott
    ____________________________________________________________

  From: [EMAIL PROTECTED]
  [mailto:[EMAIL PROTECTED] On Behalf Of Hari
  Sent: Tuesday, June 10, 2008 3:01 PM
  To: [email protected]
  Subject: [OSL | CCIE_RS] EBGP Multihop
  Hi all,

  While configuring EBGP Multihop command in BGP , do we need to
  configure IGP route or static route for that particular neighbor?

   Is it mandatory to configure IGP route or static route ?

  Thanks
  Hari
    ____________________________________________________________

  Bring your gang together. Do your thing. [1]Find your favourite
  Yahoo! Group.

References

1. http://in.rd.yahoo.com/tagline_groups_9/*http://in.promos.yahoo.com/groups/
-- 
This message is intended for the individual(s) to whom it is addressed and may 
contain information that is privileged or confidential.
If you are not the addressee you must not read,use or disclose the contents of 
this email.
Whilst all reasonable care has been taken to avoid the transmission of viruses, 
the recipient should carry out virus and other checks,
as they consider appropriate.
Myself accepts no responsibility in this regard.


Reply via email to