Just use "show interfaces <interface> switchport" and you will see what encap is used
On Tue, Mar 8, 2011 at 7:12 AM, Scott Sierra <[email protected]> wrote: > Actually my previous answer was incorrect as I didn't specify the > interface. Lets try that again... > > Switch(config-if)# switchport trunk encapsulation dot1q > > > -----Original Message----- > From: [email protected] [mailto: > [email protected]] On Behalf Of Narendra > Sent: Tuesday, March 08, 2011 5:13 AM > To: marc abel > Cc: [email protected]; [email protected] > Subject: [OSL | CCIE_RS] how to use encapsulation dot1q > > hi guys, > > when i use layer3 switch 3750 for intervlan routing but i dont use any of > the encapsulation command then which encapsulation method it uses. > and if does not use dot1q encapsulation then how can i enable dot1q > encapsulation in my network. > > > -- > Best Regards, > > Narendra Prasad > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > Please note: This email and its content are subject to the disclaimer as > displayed at the following link > http://www.is.co.za/legal/E-mail+Confidentiality+Notice+and+Disclaimer.htm. > Should you not have Web access, send a mail to [email protected] and a > copy will be emailed to you. > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
