yes i have done it thanks to all
On Tue, Mar 8, 2011 at 2:49 PM, Narendra <[email protected]> wrote: > dear prabha > i have tried this command its working but my question is this that why am i > having to issue this "switchpot trunk encapsulation dot1q" command to this > layer 3 switch. > becoz i have another main layer3 switch it that switch i didnot se this > command but it working well. > > then why am i having to issue this command? any reason > > Regards > Narendra > > On Tue, Mar 8, 2011 at 2:46 PM, prabha ganesan <[email protected]>wrote: > >> Hi Narendra, >> >> Please try the below configuration. >> >> switch(config)#int gi 0/1 >> switch(config-if)#switchport trunk encapsulation dot1q >> switch(config-if)#switchport mode trunk >> switch(config-if)#exit >> >> Thanks, >> Prabha >> >> On Tue, Mar 8, 2011 at 2:23 PM, Narendra <[email protected]> wrote: >> >>> Hi guys >>> >>> please help me, i m unable to make a port trunk >>> >>> Switch(config)#int gi0/1 >>> Switch(config-if)#switchport mode trunk >>> Command rejected: An interface whose trunk encapsulation is "Auto" can >>> not >>> be configured to "trunk" mode. >>> >>> -- >>> Best Regards, >>> >>> Narendra Prasad >>> _______________________________________________ >>> For more information regarding industry leading CCIE Lab training, please >>> visit www.ipexpert.com >>> >> >> > > > -- > Best Regards, > > Narendra Prasad > > -- Best Regards, Narendra Prasad _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
