For more clarification on this, please refer to SWITCH 642-812 official certification guide, page 189
On Tue, Nov 15, 2011 at 3:39 PM, Pedram Zadeh <[email protected]>wrote: > Sorry Asif, but I would say your answer is not correct. > > Amit if that is all your topology, just configure it in your access ports. > (However, it is not recommended to have R5 as root in this topology; root > usually should be in middle of your network. R4/R3 are much better for > that; and also for access ports having portfast+bpduguard is better > solution) > > All redundant ports between switches potentially could be root port as I > mentioned in the other posts and shouldn't be configured with root gurad. > > 2011/11/15 Syed Asif Raza <[email protected]> > >> Enable root guard on interfaces between R3 and R1 R4 and R2. >> >> >> >> >> >> ------------------------------ >> Date: Tue, 15 Nov 2011 08:59:22 +0530 >> Subject: Re: [OSL | CCIE_RS] Rootguard placement >> From: [email protected] >> To: [email protected] >> CC: [email protected]; [email protected]; [email protected]; >> [email protected] >> >> >> >> hi guys, >> >> Yes all i want is R5 to be the root and there is no notion of secondary >> root bridges.. >> So now with the below diagram kindly let me know on what interfaces >> should root guard be enabled? >> >> >> >> >> >> R5 >> | | >> | | >> | | >> R3---------R4 >> | | >> | | >> R1---------R2 >> > > _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
