Hi Mark, Did you changed mpls label protocol from tdp to ldp on all interfaces between r2 and r5? A previous task requires you use tdp as label protocol but pseudo-wire apparently requires ldp...
Regards, Christophe On 29 Nov 2011, at 14:54, mark salmon wrote: > I am doing section 3.0 of Lab 9 WB3, more specifically 3.3. Seems easy > enough, well router 2 is a 7206 with over 512 meg of ram and running 12.4(24) > t. Every time i create the xconnect, it crashes the router!! Has anyone been > able to do section 3.2 successfully? > > My commands are: > > r2 > > interface fast 0/0.211 > encapsulation dot1q 211 > xconnect 70.18.2.5 52 (vlan ID on remote) > > > on R5 > > interface fast 0/1.52 > encapsulation dot1q 52 > xconnect 70.18.2.2 211 > > I took the configuration off to prevent the router from crashing. > > > > "Question with boldness even the existence of a God; because, if there be > one, he must more approve of the homage of reason, than that of blind-folded > fear." Thomas Jefferson > " Where ignorance is bliss 'tis folly to be wise" > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > > To Unsubscribe from this list please visit the following link and follow the > directions to unsubscribe. http://onlinestudylist.com/mailman/listinfo/ccie_rs _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
