Anybody have an idea how Cat2 could show the RIP routes it's supposed to get?
Verified the transport b/t R2 & R5 is up, however not getting any routes. The
default configs were wrong and had to modify the ip addressing on Cat2. It was
in the wrong subnet. Confirmed RIP is configured on both BB1 and Cat2.
Pod1-R2(config-subif-xconn)#do sh mpls l2transport vc 25 det
Local interface: Fa0/0.211 up, line protocol up, Eth VLAN 211 up
Destination address: 70.18.1.5, VC ID: 25, VC status: up
Output interface: Fa0/0.25, imposed label stack {30}
Preferred path: not configured
Default path: active
Next hop: 70.18.25.5
Create time: 00:00:22, last status change time: 00:00:21
Signaling protocol: LDP, peer 70.18.1.5:0 up
MPLS VC labels: local 200, remote 30
Group ID: local 0, remote 0
MTU: local 1500, remote 1500
Remote interface description:
Sequencing: receive disabled, send disabled
VC statistics:
packet totals: receive 0, send 0
byte totals: receive 0, send 0
packet drops: receive 0, seq error 0, send 0
Thank you,
Chris
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com
http://onlinestudylist.com/mailman/listinfo/ccie_rs
