Hi, You are probably missing the "encapsulation" command to define what vlan this subinterface is used for.
Kim On Thu, Apr 12, 2012 at 9:37 AM, khaled al-ajeman <[email protected]> wrote: > Hi fellas, > > I am trying to configure my sub interface as vrf interface but, > unfortunatly it is not allowing me at all, can you please help me out in > this matter. > > configuration as follows: > > R8(config)#int f0/0.22 > R8(config-subif)#ip vrf for > R8(config-subif)#ip vrf forwarding cust-A > R8(config-subif)#ip add 100.100.200.8 255.255.255.0 > > > % Configuring IP routing on a LAN subinterface is only allowed if > that -----------------------> this is what I am getting, > can you please help me on that matter ? > subinterface is already configured as part of an IEEE 802.10, IEEE 802.1Q, > or ISL vLAN. > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > > http://onlinestudylist.com/mailman/listinfo/ccie_rs -- // Freedom Matters // CCIE #29189 // www.packet-forwarding.net _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
