All, This is a genral syntax question more than anything. I am doing lab 2-14. I am on task 1.0: Configure R2 Frame-Relay Interfaces so that IP traffic with a datagram size above 512 bytes will be marked Discard-Eligible (DE). Here is what I did: access-list 1 permit any
class-map match-all FRDE match access-group 1 match packet length min 512 policy-map SETDE class FRDE set fr-de interface Serial0/1/0.24 point-to-point bandwidth 512 ip address 150.50.24.2 255.255.255.252 frame-relay interface-dlci 204 //disregard dlci number my FRSW is different service-policy output SETDE The DSG says: frame-relay de-list 1 protocol ip gt 512 int s0/1/0.24 frame-relay de-group 1 104 int s0/1/0.25 frame-relay de-group 1 105 int s0/1/0.26 frame-relay de-group 1 106 I thought that Cisco is really driving more usage of the MQC? My biggest fear in the lab (June 18th) is that I will lose points because I used different syntax than what was expected. Does the grading script care about syntax or does it look for output commands? For example: R2(config)#do ping Protocol [ip]: Target IP address: 150.50.24.1 Repeat count [5]: 1 Datagram size [100]: Timeout in seconds [2]: Extended commands [n]: y Source address or interface: Serial0/1/0.24 Type of service [0]: Set DF bit in IP header? [no]: Validate reply data? [no]: Data pattern [0xABCD]: Loose, Strict, Record, Timestamp, Verbose[none]: Sweep range of sizes [n]: y Sweep min size [36]: 500 Sweep max size [18024]: 600 Sweep interval [1]: Type escape sequence to abort. Sending 101, [500..600]-byte ICMP Echos to 150.50.24.1, timeout is 2 seconds: Packet sent with a source address of 150.50.24.2 !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! . Success rate is 98 percent (70/71), round-trip min/avg/max = 256/275/292 ms R2(config)#do sh frame pvc 204 PVC Statistics for interface Serial0/1/0 (Frame Relay DTE) DLCI = 204, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE = Serial0/1/0.24 input pkts 347 output pkts 296 in bytes 146234 out bytes 133949 dropped pkts 0 in pkts dropped 0 out pkts dropped 0 out bytes dropped 0 in FECN pkts 0 in BECN pkts 0 out FECN pkts 0 out BECN pkts 0 in DE pkts 0 out DE pkts 146 out bcast pkts 111 out bcast bytes 39373 5 minute input rate 2000 bits/sec, 2 packets/sec 5 minute output rate 2000 bits/sec, 2 packets/sec pvc create time 00:55:21, last time pvc status changed 00:54:05 Since the show output has packets marked discard eligible, I have satisfied the requirements of this task, correct? Thanks, Nick _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
