Hello,
If the below request is not in the proper channel / mailing list , please guide
me, This is the first post into this mailing list.
In Vol 1 lab32, the Tunnel mode was used to be ipv6ip , i did the lab initially
without having a look at solution, but later found that we should use ipv6ip
mode for tunnel interface between r2 and r5 ? Is there any specific requirement
as i could ping across everything without using the mode ?
Also, there was an acl to allow the tunnel ip's on R7,8,9 , which i did not
require.
Please advice about tunnel mode and acl ?
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com
http://onlinestudylist.com/mailman/listinfo/ccie_rs
