On the labs? I haven't touched the labs yet... I am still in theory mode...
Jonathan On Mon, Apr 7, 2008 at 7:36 PM, Scott Monasmith <[EMAIL PROTECTED]> wrote: > Jonathon, > > Have you ever ran into a problem where if you shut down the serial interface > (to HQ) the PRI doesn't come up, but if you shut the callmanager service on > both servers instead, then the PRI comes up fine? > > > > On Mon, Apr 7, 2008 at 7:28 PM, Jonathan Charles <[EMAIL PROTECTED]> wrote: > > > Well, if you don't do auto (which I usually do when I deploy at > > customers, then I shut it off...); then you have to make sure you have > > service mgcpapp on the dial-peers... which is amusing cuz, they aren't > > usually automatically created (sometimes yes, sometimes no). > > > > > > Jonathan > > > > > > > > > > On Mon, Apr 7, 2008 at 7:19 PM, Paul and Bobs <[EMAIL PROTECTED]> > wrote: > > > Yip I just shut down the serial interface aswell. > > > do you use the auto configuration of mgcp or manually configure this. > The > > > auto would be quicker but are they testing the knowledge of a full > > > configuration > > > > > > > > > > > > On Tue, Apr 8, 2008 at 10:50 AM, Jonathan Charles <[EMAIL PROTECTED]> > > > wrote: > > > > Once the phones go into fallback, the H323 dial peers will take over, > > > > basically because the auto-generated MGCP pots dial peers have no > > > > destination-pattern, so they are ignored... > > > > > > > > The reverse is also true; when the GW is under MGCP control > > > > (registered to CCM); the H.323 config is ignored. > > > > > > > > Basically you need to set up an ACL to block SCCP (to force the phones > > > > into fallback) and another ACL to block MGCP (2427 and 2428) so that > > > > MGCP will unregister... > > > > > > > > However, if you are lazy (I am); I would just shut down the serial > > > > interface to the WAN... > > > > > > > > > > > > > > > > Jonathan > > > > > > > > > > > > > > > > > > > > On Mon, Apr 7, 2008 at 6:47 PM, Paul and Bobs <[EMAIL PROTECTED]> > > > wrote: > > > > > When BR1 has been configured as MGCP router adn you configure the > SRST > > > and > > > > > want to test, how do you get the dia-peer pots with the service > MGCPAPP > > > not > > > > > to answer the incoming calls. DO you have to remove this config or > is > > > there > > > > > some automatic way to get srst to use the pots dial-peer when it is > on > > > > > control. > > > > > > > > > > Paul > > > > > > > > > > > > > > > > > > > > > -- > "There are only 10 types of people in the world: Those who understand > binary, and those who don't"